ATI TV enable/disable startup message?

[broaddd]

I keep getting an XP startup message about TV display being enabled, and my Macbook seems set to 60hz on the LCD, but don't know what to do about this. The onscreen prompts don't help. Anyone else? Would appreciate any suggestions.

Cheers,
Brruce

[nach0]

In my experience with ATI stuff, its a 3rd party program that brings up TV and multi monitor settings, usually the window that pops up has a 'dont show this again' option to tick at the bottom left of the windows, you might have to go into the display properties and go into the advanced settings to get to ATI's software for more settings and options..

hope this helps (you can also change refresh rates)
now this info is based on working from an 'actual' PC, im not familiar with Apples ATI driver setup..

[chaugen]

So, I had the same error message, and was similarly unable to do anything about it but turn off the error message.

And I have been having another problem with my video crashing -- it freezes up for a few seconds, then the screen goes black for a couple seconds, before the following message comes up:

> VPU recover has reset your graphics
> accelerator as it was no longer responding
> to graphics driver commands

This happens every five minutes or so. Any ideas on what's wrong?

Thanks,
Chris